Uncategorized


  • Electrical, Electronic Wiring – Part II, Curves WB

    In Part One, I explored creating wiring using only the pre-installed workbenches and FreeCAD. This approach is difficult and remains difficult for editing. The major limitation is the inability to […]

  • Electrical, Electronics Wiring

    Just a walk through of how I accomplished this silly thing. This is not a fully fleshed out article just sort of notes. Warning: This is a more advanced topic […]

  • FreeCAD Part Design – Basic Sketch Attachment

    Positioning Sketches in FreeCAD and specifically in Part Design can be a source of frustration. This short tutorial demonstrates the basic operation of adding “Support” using the “Map Mode” dialog. […]

  • Draft Dimension as Parameter.

    Often it is necessary to use the measurement of one object as the input for a calculation. This can be easy if you are grabbing the value from a sketch […]

  • Move Along

    I hope for this site to become a usefull addendum to the Official FreeCADweb.org site. However, for now, and the foreseeable future it is quite useless, a mere curiosity. It […]